A commercial product that is structural and pleasing to the eye. This panel can be installed in low slope applications and rounds out our line of mechanically seamed panels.
Snap! Pop! It's on. The 1.5" Snap-On is quick and easy. This panel provides a highly water-resistant seam, along with a lower profile for a look that is unobtrusive.
It's a snap, and it's structural. With the visual appeal of broad width seams and the practical appeal of easy, fast installation, this product is the way of the future.
Slim seams and flat pans make this product an ease to install with minimal waste. Perfect for curved roofs, mansards, and other steep-slope installations.
The long-time favorite for the traditional bold look. Wide battens bring the visual appeal of the past together with the ease of today's modern metal roofing construction.
The flush, flat look with quick-to-install interlock ing seams. The seamless look you desire for walls, soffits, and equipment screens is accomplished with this product.
MetShield resists high temperatures (up to 240°) and prevents water penetration from melting ice and wind-driven rain.
MetShield Water and Ice Protection is a 40 mil rubberized asphalt sheet membrane underlayment specifically designed for high temperature applications typically found under standing seam metal roof installation. MetShield provides dual barrier protection. The composite membrane consists of rubberized asphalt laminated to an impermeable high tensile strength polyethylene film. It will prevent water penetration from wind-driven rain and water back-up caused by ice or debris. MetShield performs so well that it is required under many metal roof warranted systems.
MetShield Primer is a single component, water-based primer designed to aid in the adhesion of MetShield Waterproofing Membranes. It performs especially well setting the dust on concrete and block surfaces before the application of the membrane. It may be sprayed or rolled onto the surface. Normal dry time is approximately 30 minutes depending on job site conditions. Membrane must be applied within 24 hrs. or surface must be re-primed.
